Direkter Download von dieser Webseite :
@User47 Never even thought about it. LibreOffice was the tool of my choice. You could also youse LibreOffice Draw or even impress. 😉
@Hexangon Berichte mal, wie du weiter verfährst. Ich hab hier einen älteren, echten HP Server, den ich auch mit Proxmox verbasteln will. Hab auch kurz an Unraid gedacht. Aber da ging die Freigabe nicht auf Anhieb. Muss ich nochmal ran. Aber Proxmox klingt sehr spannend. Kann das nicht auch RAID und Speicher bereitstellen? Und vielleicht sogar nen reverse Proxy out of the box? 😬
@User47 Last thing: After you set the labels for your desired rolls and sizes, you go to LibreOffice and set your pagesize. When you go to print, make sure you use the correct label printer AND the correct label size. Make sure you save the file again afterwards. This should save all the printer settings (paperrollsize, printer) to the file.
@User47 The EXACT PRINTER NAME is crucial. QL700 is not the same as QL-700 (dash inbetween). Check the Name of the printer in your CUPS or Printer-Administration-Page of your System.
For the Dimensions: you can change them as desired. For bigger Folders I use:
sudo brpapertoollpr_ql700 -P QL700 -n BroadFolder -w 62 -h 192
Check out this help-Page from Brother: https://support.brother.com/g/b/faqend.aspx?c=ca&lang=en&prod=lpql700eus&ftype3=100217&faqid=faqp00100418_001
@User47
1. Did you install the driver?
2. Did you enterd the desired dimensions of Paperroll you put in?
sudo brpapertoollpr_ql700 -P <EXACT PRINTER NAME> -n <DESIRED LABELNAME> -w 29 -h 192
After finishing Step 2 you can just open up a LibreOffice Document. Modify the "Page Dimesons" like here 29mm x 192mm. And then go ahead and style your desired Sticker.
The above example is for small Folders. I am using this Dimensions with a 29mm - infinite Sticker-Roll.
